Table of Contents
Advertisement
Ofolalarzzendiale meu cem £e)at-m (101010) ol-16 mv iidam-lem~ male l-comele
| ¢oleial(-(e1.0mcolmc-iel-m:reli clare]
<*>: Signal flow
YC-15V/30V
(not supplied)
Preparing for use/Operating the equipment
Same as p. 15.
* It is not necessary to connect to the MONITOR OUT S VIDEO
Jack to receive the S video input signal. You can make the
connection as shown above, or connect the MONITOR OUT
jacks to the VCR for recording, using the VMC-810S/820S
connector (not supplied).
(Rear of TV)
MONITOR OUT
S VIDEO+
YC-15V/30V
not supplied
(not supplied)
(
Epned)
qwewdynbdy
semo
Gugseuue)
:
wali
to audio
(for recording)
Notes
¢ Do not change the input signal while eating through MONITOR
OUT, or the output signal will also change.
¢ When connecting a single VCR to the TV, do not connect the
MONITOR OUT jacks at the rear of the TV to the VCR's line
input, while at the same time connecting from the TV's VIDEO IN
jacks to the VCR's line output, as shown below.
(Rear of the TV)
VIDEO IN fl tioer
MONITOR
VHF/UHF 4]
[+
The above type of connection is not a problem when you connect
from the line input of one VCR, and from the line output of a
second VCR.
Chapter 1: Setting Up | 1 7
Advertisement
Table of Contents
