Honeywell ImperLED Quick Start Manual

Dimensional Drawings:
Installation:
1
4
Adhesive tether
loop
Step 1: Place a flat blade screwdriver and pull up gently the diffusor's clips from both sides to remove the diffusor.
Step 2: Place a flat blade screwdriver and pull up gently the reflector.
Step 3: Install the plastic base with the included mounting screws and plugs. If the hole that exists is not useful,
drill another hole on one of the designated positions in order to pass the cables and install the included
gasket (verify that are not deformed).
Step 4: Install the included rubber gasket (verify that is not deformed). Make a hole in the center of the rubber
gasket by using a small screwdriver. Pass the round cable through the rubber gasket. Install the included
tie-wrap to the included adhesive tether loop and fasten securely the power cable in order to anchor it.
Install the power cable as shown in the picture. Always use in any case round mains cable, with a diameter
of 5-10mm (H05RN-F type 2x1mm ) or any other type, at least equal to it's mechanical and electrical
properties). ATTENTION!! The cable must not be deformed in any way (This requirement is important to
ensure the IP rating).
Step 5: Connect the 24V cable to the respective terminal block: C1 and C2. Power supply cables cross section
should be 0.8 – 3 mm . Open a second hole on the plastic base, install the rubber gasket and pass another
one 24V cable . Connect the second 24V cable to the respective terminal block: C1 and C2 and connect it
to the next luminaire.
Step 6: Refit carefully the removed plastic parts. Finally place the diffusor. Attention!! The plastic lathces (A)
must be secured (click sound). This requirement is important to ensure the IP65 rating. Power on the
luminaire.
Honeywell Life Safety AS, Postboks 236, 1372 Asker
Surface Mounted
2
5
24V IN
24V IN
17-27V AC/DC
To other luminaire
To other luminaires
2
ImperLED
24V IN
24V IN
24V OUT
24V OUT
2
3
6
A A
A A
http://www.hls-nordic.com
GB
A
A