Table of Contents
Advertisement
Items Needed
NLGI#2 Grease or Equivalent ........... As Needed
ISO 32 Oil or Equivalent .................... As Needed
80-90W Gear Oil ............................... As Needed
Clean Shop Rags .............................. As Needed
Mineral Spirits .................................... As Needed
Brushes ............................................. As Needed
1-Gallon Catch Pan ........................................... 1
Grease Gun
⁄
" NPT ......................................... 1
1
8
Hex Wrenches 3, 4mm ................................1 Ea.
Roller Lubrication & Chain Grease
Fittings
Lube Type ............. T26419 or NLGI#2 Equivalent
Amount ................................................1–2 Pump
Lubrication Frequency .......200 Hrs. of Operation
Grease Gun ....................................................... 1
Wipe the roller lubrication points and chain grease
fittings clean and lubricate with one pump from
a grease gun filled with NLGI#2 grease (see
Figures 35–36). Spread the grease around the
roller lubrication points.
to remove the chain cover to access the chain
grease fittings.
Roller Lubrication Points
Figure 35. Location of roller lubrication points.
Grease Fittings
Figure 36. Location of chain grease fittings
(chain cover removed).
-28-
Qty
It will be necessary
Gearbox
Lube Type .................................80-90W Gear Oil
Amount ...................................................4.05 Oz.
Lubrication Frequency:
•
200 Hrs./First Month of Operation
•
1000 Hrs./6 Months of Operation
The gearbox should be drained and refilled after
the first month or 200 hours of use. For the
remaining life of the power feeder, change oil
every six months or 1000 hours of use.
To change gearbox oil:
1.
DISCONNECT MACHINE FROM POWER!
2.
Rotate power feeder off of machine table,
remove chain cover, and tighten rotation lock.
3.
Rotate power feeder upside down so chains
face down.
4.
Place drain pan under plug labeled "OIL,"
then remove plug (see Figure 37) and drain
oil.
Oil Sight
Glass
Figure 37. Location of gearbox plug/oil drain and
sight glass.
5.
Rotate power feeder 180 degrees so chains
are facing up, fill gearbox with oil until oil level
is at halfway point in sight glass, then replace
plug.
6.
Install chain cover and rotate power feeder
back into position for operation.
Model T33295 (Mfd. Since 03/23)
Plug
Advertisement
Table of Contents
