Resizing.32 - Panasonic PT-L701 XU Operating Instructions Manual

NOTE:
• This projector is equipped with an
aspect ratio selection function.
However, if a mode which does
not match the aspect ratio of the
input signal is selected, it may
affect the quality of viewing of the
original picture. Keep this in mind
when selecting the aspect ratio.
• If using this projector in places
such as cafes or hotels with the
aim of displaying programs for
viewing for a commercial purpose
or for public presentation, note
that if the aspect ratio (16:9)
selection function is used to
change the aspect ratio of the
screen picture, you may be
infringing the rights of the original
copyright owner for that program
under copyright protection laws.
• If a normal (4:3) picture which
was not originally intended for
wide-screen viewing is projected
onto a wide screen, distortion
may occur around the edges of
the picture so that part of the
picture is no longer visible. Such
programs should be viewed in 4:3
mode to give proper
consideration to the aims and
intentions of the original
program's creator.
RESIZING
This should normally be set to "ON".
(This setting is only for signals
which have lower resolutions than
the LCD panels. Refer to page 50
for details.)
ON The pixel resolution of the
input signal is converted to
the same resolution as the
LCD panels before being
projected. For signals with
lower resolutions, gaps in
the pixels are
automatically interpolated
into the picture before it is
projected. This may
sometimes cause
problems with the quality
of the picture.
OFF The picture signal is
projected at its original
resolution, with no pixel
conversion. The projected
picture will be smaller than
normal, so adjust the
zoom setting or move the
projector forwards or
backwards to adjust the
picture size if necessary.
32