Makita RP1100 Instruction Manual page 7

Straight guide (optional accessory)
► 1. Hex socket bolts 2. Straight guide
The straight guide is effectively used for straight cuts
when chamfering or grooving.
To install the straight guide, insert the guide bars into
the holes in the tool base. Adjust the distance between
the bit and the straight guide. At the desired distance,
tighten the hex socket bolts to secure the straight guide
in place.
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
If the distance between the side of the workpiece and
the cutting position is too wide for the straight guide, or
if the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a
straight board to the workpiece and use it as a guide
against the base. Feed the tool in the direction of the
arrow.
Templet guide (optional accessory)
1
2
The templet guide provides a sleeve through which
the bit passes, allowing use of the tool with templet
patterns.
To install the templet guide, insert the templet guide in
center hole in the base plate and secure in place with
the lock nut.
► 1. Lock nut 2. Templet guide 3. Router bit 4. Base
plate
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
► 1. Router bit 2. Base 3. Templet 4. Workpiece
5. Templet guide 6. Lock nut
7 ENGLISH
1
2
4
3
6
5