Requirements Of Operator To Register The Rlan Device Operating Outdoors In The 5150 -5250 Mhz Band And Addressing Possible Interference Issues In This Band; Industry Canada; Canadian Compliance Statement - Cisco Aironet 1540 Series Hardware Installation Manual

Appendix B Declarations of Conformity and Regulatory Information
Requirements of operator to register the RLAN device operating Outdoors
in the 5150 -5250 MHz band and addressing possible interference issues in
this band
Section 15.407(j) of the rules established filing requirements for U-NII operators that deploy a collection
of more than 1000 outdoor access points with the 5.15-5.25 GHz band, parties must submit a letter to
the FCC lab acknowledging that, should harmful interference to licensed services in this band occur, they
will be required to take corrective action. Corrective actions may include reducing power, turning off
devices, changing frequency bands, and/or further reducing power radiated in the vertical direction.
This material shall be submitted to:
Federal Communications Commission
Laboratory Division, Office of Engineering and Technology
7435 Oakland Mills Road, Columbia, MD, 21046
Attn: U-NII Coordination
or via website at
use subject line U-NII Filing

Industry Canada

Canadian Compliance Statement

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire
de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
https://www.fcc.gov/labhelp
Models:
AIR-AP1542I-A-K9
AIR-AP1542D-A-K9
Cisco Aironet 1540 Series Outdoor Access Point Hardware Installation Guide
IC Certification Number:
2461B-102109P

Industry Canada

B-3