Energy Saving Function; Cleaning, Care And Maintenance; Troubleshooting - Buffalo CP799 Instruction Manual

NOTE: If unsuitable cookware or no cookware is present the induction cooker will display
'E0', then switch off automatically.
• To use the timer press the timer button
indicator light will illuminate. Press the Increase
cooking time (Range: 0 - 180 minutes).
• Pressing the on/off button
to run for 1 minute to cool the appliance, then switch off automatically.

Energy saving function

If the appliance is switched on with inactivity for 2 hours, it will switch off automatically.
Cleaning, Care & Maintenance
Disconnect from the power supply and allow the appliance to cool before
cleaning.
• Use warm, soapy water and a damp cloth to clean
the appliance.
• DO NOT use abrasive cleaners or pads.
• Dry thoroughly after cleaning.
• There is a removable air filter on the bottom of the
appliance. Pull it out of its slot and clean with a
vacuum cleaner.

Troubleshooting

A qualified technician must carry out repairs if required.
Fault
The unit is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
"E0" on Display No/Unsuitable cookware
"E1" on Display Appliance has overheated
"E2" on Display Temperature of pan is too high
(Pan is dry or empty)
"E3" on Display Input voltage is too high/low
CP799_ML_A5_v6_20230629.indb 5 CP799_ML_A5_v6_20230629.indb 5
. The LCD display will switch to Timer and the Timer
or Decrease button
during use will stop the operation immediately. But the fan will continue
Probable Cause
Check unit plugged in correctly and switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Replace with suitable cookware
Check ventilation slots for blockages. Allow to
cool before attempting to use again.
Remove cookware. Allow to cool before
attempting to use again.
Make sure the mains power supply is suitable
for the appliance.
to select the desired
Removable air filter
Solution
EN
5
2023/6/29 14:55 2023/6/29 14:55