Kenwood 1050CD Instruction Manual page 22

In case of difficulty
Operation to reset
The microcomputer may fail into malfunction (impossibility to operate, erroneous dis-
play, etc.) when the power cord is unplugged while power is ON or due to an external
factor. In this case, execute the following method to reset the microcomputer and
return it to normal condition.
Sympton Cause
No power is applied with the POWER Insert the power plug firmly to the AC outlet.
switch ON. @ Turn the amplifier's power ON.
Unpiug the power cord from the power socket and
plug the power cord into the socket again.
® Power plug is foosely connected.
e With the power plug connected to the
switched AC outlet of an amplifier, the power
of the amplifier is turned off.
@ Load the disc again with tts label side up.
@ Insert disc propertly.
@ Wipe off the dust on the surface of the disc
referring to "Disc handling precautions".
e@ Replace the disc with a new one.
e Leave the player for about 1 haur so that the
condensation is removed.
Disc is loaded upside down.
Disc is loose
Disc is dirty.
Disc is loaded, player does not play.
@ Disc is cracked.
e@ Condensation occurred on the optical lens
unit.
@ Disc is too dirty. e Wipe off the dust on the disc surface refer-
ring to "Disc handling precautions".
Music is interrupted. (Sound is @ Disc is too dirty. e Wipe off the dust on the disc surface refer-
skipped.}
ring to "Disc handling precautions".
e@ Oscillation is applied to this unit. @ Try selecting a place where no strong vibra-
tions occur by changing the installation place,
etc.
Disc begins to play when power is e The CD player will automatically play when a | @ To avoid disc playing automatically, remove
: switched ON. disc has been inserted and power is switched disc before switching off power.
ON. |