Kenwood 1050CD Instruction Manual page 13

Mm Listening from the desired track
To skip tracks
1 Make sure the PGM indicator is extinguished.
indicator goes off.
—
" hy
To skip backward To skip forward
2 Select the desired disc.
@When theft] key is pressed once during play, the track starts
again from the beginning
ofc 4 omc 2 osc 3 omc 4 Osc 5
CJ C3 Co
or
Ay Remote control unit
Main unit (Except for 103CD}
3 Select the desired track.
To fast forward and backward
Main unit Remote control unit
(Except for 103CD)
6 6
GyYexe
a
As
@ 9
Cc
6 6
f}
Fast-forward Fast-reverse |
e@ The track will start to play from where you release the key.
| , 4 3 i=]
7
@ Keep pressing the Examples of input
key control the de- Track No.7:
sired track number | Track No. 11 - (1}
is selected. Track No. 20 : (0)
e Play starts from the selected tune and after.
@ Listening through headphones (Except for 103CD)
1 Insert the headphone plug into the headphones Adjusting the output levels of the output jacks and
headphone output
The level (DOWN, UP) keys of the remote control unit can
adjust the output levels from the AUDIO OUTPUT and PHONES jacks
of the unit.
@\t is not favorable for the sound quality to decrease the output level
from this unit too much.
@Adjusting the headphone output level also changes the AUDIO
OUTPUT level. Be careful in operating these keys particularly dur-
ing recording.
:
e Note that the headphone output level and the AUDIO OUTPUT level
2 Adjust the volume.
becomes maximum when the power is turned on.
OUTPUT
Remote control unit oni
Ay y Displayed for about 2 seconds
Output level
1O50CD/104CD/103CD (En) 13