Table of Contents
Advertisement
condensed
operating
instructions
This is a condensed check list only. For trouble-
free operation and best projection results, be
sure to read this book carefully before operating
your projector.
1. Place the projector on a stand or table a suit-
able distance from the screen.
2. Plug in the power cord.
3. Attach the Auto Reel to the rear takeup spin-
dle and the reel of film to be shown to the front
spindle.
4. Select the proper threading position for Super
8 or regular film by pushing in the appropriate
shaft (see page 4). When the selective sprocket
system is set for Super 8 projection, the letter S
appears
in the indicator window;
for regular
8mm
projection, the letter R appears
in the
window.
5. Push the green threading
lever down
(to-
ward the lens).
6. Trim the end of the film leader with the film
cutter (see page 5) and insert the end of the film
leader into the threading slot. The film will
thread automatically to the takeup reel, at which
time the projection lamp will turn on.
7. Turn the motor switch to RUN and the lamp
switch to ON.
8. Once projection begins, adjust the following,
if necessary:
A. Focus (by turning the focusing knob).
B. Projection speed (with the speed control).
C. Framing (with the framing lever).
D. Image size on the screen (if your projector
is equipped with a zoom lens).
9. When the complete roll of film has been pro-
jected, rewind the film as follows:
. Turn off the lamp and motor.
. Insert film end into slot on supply reel.
. Turn speed control knob to HIGH.
. Push in the reverse button while turning
the motor switch to RUN. The film will
now be rewound at high speed.
. Turn the motor switch off.
Advertisement
Table of Contents
