Preparing For Playback - Kenwood VR-209 Instruction Manual

PORE IIIS
MLLER SPRAY AILELISEDESELOLECSLBRERL sobteeomeneRe7! Fines EIGER Ce
input level adjustment (analog sources only)
© Press the SOUND key several times until the "INPUT" indication
appears.
© Use the MULTI CONTROL (TUNING/SKIP) to adjust the input
level so that the CLIP INDICATOR no longer lights.
mo:
| Oo Oaivr tt oy 7
¢ The input level may be adjusted to any one of three settings: 0.
-3, and -6. (The initial setting is 0.)
@ Press the SOUND key to return to the input indication.
* If you used the remote control to perform the above setting, press
the VIDEO key at this point to turn off the remote control's own
adjustment mode. In this case. the input source is not switched.
Preparing for playback
SN rn CoN Labs Ss BRS a ct
Some preparatory steps are needed before starting playback.
(INPUT MODE
ON/STANDBY AUTO
|
=o 18
iNPUT SELECTOR
SPEAKERS A/B
PERE CCR RELIANT ee BOSE ES ANN ck MT NR itt
Turning on the receiver
@ Turn on the power to the related components.
@ Turn on the power to this receiver by pressing POWER (and ON/
STANDBY) key(s).
FERRIES LES NOIRE LIES LEGGE LLG ELSES NA OBES EIU ES LEN i OBE CELINA Nt tc acm
Selecting TAPE/MD
Select the source name corresponding to the component connected
to the MD/TAPE jacks. The initial factory setting is "TAPE". To change
the source name associated with the MD/TAPE jacks to "MD." foliow
the steos beiow:
@ Use the INPUT SELECTOR knob to select "TAPE".
© Hold down the AUTO key for more than two seconds.
* The source indication changes to "MD".
* To return to the original indication, repeat the above procedure.
© You also will need to change the name input to the remote contro!
to "MD" RC- 3
RRR SS eh NE IN
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to
be used.
AON : Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.
BON : Sound from the speakers connected to the SPEAKERS B
terminalis on the rear panel.
: Sound from both the speakers connected to the SPEAK-
ERS A and B terminals on the rear panel.
A+B OFF : Nosound from the speakers. Use this setting when listen-
ing with headphones for stereo sound in all playback
modes.
A+B ON
elf you activate a surround mode. speaker system A is selected
automatically.
Selecting the input mode |