Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
What often appears to be a malfunction is often due to user error in operation or
connection. When trouble occurs with your unit, please check the following before
calling for service.
Cause
No sound one channel
The balance/fader control is
Adjust the balance/fader control.
extremely rotated to one side.
The antenna
is not extended.
Extend the antenna.
Tonal quality is inferior.
4
Operation switches do
not function.
ead is Stained.
Carry out head cleaning.
Press the Reset button of the
front panel.
Correct operation is not obtained
due to a sudden change in the
power voltage, etc.
Phone interface does
Phone interface lead is not
Connect it correctly according to
not function.
connected correctly.
the connecting method.
Phone interface
Conductor is contacting chassis
Wire in such a way that the
functions although it is | and so on as phone interface
conductor of phone interface
not used.
lead is clipped or the cap at the
lead does not contact chassis
(Displays ''CALL''
tip is off.
and so on.
indication).
@ When the KENWOOD
CD-changer is connected:
CD play does not start. | Power switch is not turned ON.
Turn the power switch ON, then
press the CD switch.
The specified disc is
1. The specified disc is too dirty. | 1. Clean the disc.
not played and the
2. The disc is placed upside
2. Eject the magazine and re-
next disc is played.
down.
insert the disc correctly.
3. Two discs are set in the
3. Eject the magazine and set
same position.
each disc correctly.
4. The specified disc is placed
4. Eject the magazine to check
in a position with a different
the disc number and the
number.
position number, then spec ify
again.
. Play other discs.
5. The disc is damaged or
scratched seriously.
. Volume is set to the
minimum
level.
2. The incorporated
microcomputer is not
operating correctly.
3. System connections are made
imperfectly (power cord,
connection of pre-out jacks,
or speaker connections, etc.).
No sound ts output
while the changer
indicator is shown.
. Increase the volume
level.
2. Press the Reset button of this
unit.
3. Check the connections
according to the instruction
manual. If anything is wrong,
reconnect it correctly.
Even when the required
track is specified, the
specified track is not
played or the player
does not function.
The player is set to random play. | Release random play.
(E, ) 33
Advertisement
Table of Contents
