Table of Contents
Advertisement
NAMES
AND USED OF PARTS
© VOLUME/BALANCE indicator
®
Normally, this indicator functions to display the sound
volume level.
e@ When the balance control is pressed, the indicator swit-
thes to display
the right-left
sound
balance.
After
several seconds, the indicator returns automatically to
the volume display.
®
When the MUTING switch is ON, the indicator flashes.
@ MUTING switch
Use to temporarily cut out all audio signals.
When
the
mode
display
shows
the
flashing
VOLUME/BALANCE
indicator, the function is ON, and all
sounds are cut off.
When turned OFF, the sound returns to its previous level.
The muting ON/OFF function can aiso be operated by the
accessory remote control unit.
@ GRAPHIC EQUALIZER controls/indicators
These controls can be used to emphasize or de-emphasize
sounds
in the frequency
bands
60Hz,
150Hz, 400Hz,
1kHz,
2.4kHz,
6 kHz,
15kHz,
thus allowing
you to
control tone quality. The center position of each control
is the normal
(flat) setting; when raised above the center
position, the control's frequency
band
is emphasized;
when lowered, the band is de-emphasized.
@ SPECTRUM ANALYZER
This display shows the condition of sound signals compen-
sated with the graphic equalizer controls.
{Because the level indicator is connected to the input side,
the indication does not change when the VOLUME control
is turned.)
@® EQUALIZER
ON/OFF selector switch/indicators
When
this switch
is pressed, the equalizer
indicators
light and its functions become operative. When pressed
once again, the indicators go out and its functions are
turned OFF.
Use this switch
in the following manner:
[ON]
: When
using the equalizer to add sound com-
pensation
while
performing
program
sources,
and
playing
back
and/or
recording
results.
{OFF]
: When
not
using
the
equalizer,
but
playing
back
or
recording
program
sources
without
compensation.
@ SLEEP/STD-BY indicator
This indicator lights or flashes when the accessory remote
control unit is used to turn the SLEEP key or POWER key.
When the SLEEP key is ON, the indicator will light. (Initially
it will flash slowly, then gradually become faster.)
60 minutes after the sleep timer is turned ON, the power
switch will be turned
STANDBY automatically.
@® REMOTE SENSOR window
This component features a built-in microcomputer which
will recall the last-set positions of the following switches for
up
to about
one
week
after
the power
cord
is dis-
connected.
As a result, when the power
is turned ON
again, the previously set positions will be recalled auto-
matically:
e
FUNCTION switch
®
BALANCE contro}
e®
MUTING switch
e
VOLUME control
*® EQUALIZER ON/OFF switch
When
the unit is not used for more than a week, the
memorized setting positions will be erased, and returned to
the following settings:
©
VOLUME control ....... cc eeeeeeeeesesereenseeene
MUTING switch ...
BALANCE control ..
FUNCTION
switches ......
EQUALIZER ON/OFF switch
-CENTER
TUNER
. OFF
474
<ARB1070>
Advertisement
Table of Contents
