Applicable To Us/Ca Market; Supplier's Declaration Of Conformity; Compliance Requirements - Husqvarna CEORA Operator's Manual

10.1 Supplier's Declaration of
Conformity
Issuer: Husqvarna AB, Drottninggatan 2, S-561 82
Huskvarna, Sweden www.husqvarnagroup.com.
Responsible party: Husqvarna Professional Products,
Inc. 9335 Harris Corners Parkway Suite 500 Charlotte,
NC 28269 United States U.S. Contact information:
Michael Campbell, Sr Director Quality, test compliance,
Telephone: +1 704 597 5000.

10.2 Compliance requirements

FCC ID: MCQ-XBSX (Short range device 915 MHz).
FCC ID: ZASHQ-BLE-1F (Bluetooth
robotic lawn mower).
FCC ID: XPYUBX18ZO01 (Automower
4G).
FCC ID: ZASHQ-BLE-1E (Bluetooth
charging station).
®
The Bluetooth modules are located on the application
circuit board (PCBA) in the lower chassis of the drive
unit and on the charging station circuit board in the
charging station. All circuit boards in the mower using
radio are located in the upper chassis of the drive unit.
They must only be accessed by an authorized service
technician.
WARNING:
exposure requirements, please maintain a
separation distance of at least 20 cm/7
inches from any part of the product.
Note:
Changes or modifications made to this
equipment not expressly approved by Husqvarna may
void the FCC authorization to operate this equipment.
Note:
This device complies with Part 15 of
the FCC Rules [and with Industry Canada licence-
exempt RSS standard(s)]. Operation is subject to the
following two conditions: this device may not cause
harmful interference, and this device must accept any
interference received, including interference that may
cause undesired operation.
Note:
This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
1691 - 006 - 09.01.2023

10 Applicable to US/CA market

®
module in the
®
Connect 2G/
®
module for the
To comply with RF
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
WARNING:
Harm - www.P65Warnings.ca.gov.
Cancer and Reproductive
Applicable to US/CA
market - 53