Applicable To Us/Ca Market; Supplier's Declaration Of Conformity; Compliance Requirements - Husqvarna AUTOMOWER 435X AWD Operator's Manual

10.1 Supplier's Declaration of
Conformity
Issuer: Husqvarna AB, Drottninggatan 2, S-561
82 Huskvarna, Sweden
www.husqvarnagroup.com.
Responsible party: Husqvarna Professional
Products, Inc. 9335 Harris Corners Parkway
Suite 500 Charlotte, NC 28269 United states U.S.
Contact Information: Michael Campbell, Sr
Director Quality, test compliance, Telephone: +1
704 597 5000.

10.2 Compliance requirements

FCC ID: XPY1CGM5NNN (Automower
module 2G/3G).
FCC ID: XPYUBX18ZO01 (Automower
2G/4G).
FCC ID: ZASHQ-BLE-1C (the Bluetooth
module).
®
The Bluetooth module is located on the
HMIboard (PCBA) in the upper chassis. It must
only be accessed by an authorized service
technician.
WARNING: To comply with RF
exposure requirements, please
maintain a separation distance of at
least 20 cm / 7 inches from any part of
the product.
Models without a hatch: The supplied label shall
be attached to the product according to figure
below
This device contains the module
FCC ID: XXX1YYYY2ZZZ

66 - Applicable to US/CA market

10 Applicable to US/CA market
Note: Changes or modifications made to this
equipment not expressly approved by Husqvarna
may void the FCC authorization to operate this
equipment.
Note: This device complies with Part 15 of the
FCC Rules [and with Industry Canada
licenceexempt RSS standard(s)]. Operation is
subject to the following two conditions: this
device may not cause harmful interference, and
this device must accept any interference
received, including interference that may cause
undesired operation.
®
Connect
Note: This equipment has been tested and found
®
Connect
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
®
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by switching
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
WARNING: Cancer and Reproductive
Harm - www.P65Warnings.ca.gov.
1404 - 002 -