Keypad Tones; Eol Resistor Colour Code - Bosch Solution 16plus Installation Manual

K EYPAD TO NES
Your keypad emits several distinct tones and displays text to
alert you to system events. The volume of the keypad tones can
be adjusted in MENU 6-1-0.
Type
Fire When a fire zone sounds an alarm, the keypad
Alarm
will sound 3 seconds on and 2 seconds off
Tone (repeat).
When a burglary zone activates while your
Burglary
system is turned on, your keypad emits a
Alarm
continuous siren tone. It sounds for the time
Tone
set by your security company.
When a system component is not functioning
Trouble
properly, your keypad sounds 4 fast short
Tone
beeps followed by a 5 second pause (repeat).
Pressing any key on the keypad sounds one
Key Press
short beep, indicating that the key press is
Tone
accepted.
When you enter the premises through a zone
programmed for entry delay, the keypad
Entry
sound a Hi/Low tone to remind you to turn off
Delay the area. If the area is not turned off before
Tone
the entry delay expires, an alarm condition will
sound and a report may be sent to your alarm
company.
After you turn an area All On, the keypad will
sound 1 short beep every second. During the
Exit
last 10 seconds fast short beeps will be heard.
Delay
If you don't exit before the delay time expires
Tone
and an exit delay door is faulted, an alarm
occurs.
Error If you press an incorrect key, your keypad will
Tone sound a 2 second tone.
The keypad will sound a Hi / Lo tone to indicate
Menu
you have entered MENU Mode and a Lo/Hi
Mode
tone to indicate you have exited MENU mode.
The keypad sounds fast short beeps to alert
Chime
you when a zone programmed for chime is
Tone
faulted or unsealled.
Table 8: Keypad Tone Meanings
Bosch Security Systems 05/10 BLCC100I
Meaning
Solution 16
plus Installation Manual

E OL RESISTOR COLOU R CODE
3K3 =
6K8 =
Figure 11: EOL Resistor Colour Chart
Selected Resistor Colour Codes
Value Band 1
2K2 RED
4K7 YELLOW
5K6 GREEN
8K1 GREY
10K BROWN
12K BROWN
22K RED
Table 9: EOL Resisstor Colour Codes
Because of variations in the colours used to mark resistors it is
recommended that you use a multimeter to verify the value of
resistors rather than rely on the colour code.
Installing the Hardware

Orange
Blue
Band 2 Band 3 Band 4
RED RED BROWN
VIOLET RED BROWN
BLUE RED BROWN
BROWN RED BROWN
BLACK ORANGE BROWN
RED ORANGE BROWN
RED ORANGE BROWN
2-7