Keypad Setup; Keypad Address Selection; Status Icons & Led Indicators - Bosch Solution 16plus Installation Manual

Solution 16
plus Installation Manual

K EYPAD E ME RG E NC Y AL A RM T RIGGE R 'S
Key Sequence
Ë Ê
+ Hold for 2 seconds
Ê È
+ Hold for 2 seconds
È Â
+ Hold for 2 seconds
Table 5: Keypad Emergency Alarm Trigger's
KE YPAD SETU P
The Solution 16 control panel can have a maximum of 8
plus
keypads connected via the LAN terminals. Each keypad
must be set to a unique address before they will operate.
Each keypad needs to be assigned to a home area via MENU
6-1-3. This sets the area the keypad will display and control by
default. Keypads can be locked to a home area or allowed to
roam or move between areas.
When the system is powered up, any keypads which have not
been assigned a home area will be automatically set to home
area 1.
Set each keypad address using the table below as a guide.
i Only 1 Keypad can be assigned to each address. All Keypads are
supplied from the factory set to address 1. (OFF-OFF-OFF-OFF).
Note
KE YPAD A D DR ESS SE L E CTI ON
Figure 10: Kyepad Address Selection
Keypad DIP Switch Address Settings
Keypad To Address
Keypad 1
Keypad 2
Keypad 3
Keypad 4
Keypad 5
Keypad 6
Keypad 7
Keypad 8
Table 6: Keypad DIP Switch Address Settings
2-6
Installing the Hardware

Event Triggered
Keypad Fire Alarm
Keypad Panic Alarm
Keypad Medical Alarm
4
S1 S2 S3
Off Off Off
On Off Off
Off On Off
On On Off
Off Off On
On Off On
Off On On
On On On
STAT US ICONS & LED I NDICATORS
The following table lists the function of each of the ICON
Symbols and LED Indicators on the Graphic Keypad Display.
Icon Status
The keypad can display the current status of up to
4 areas simultaneously via the Area Icon Indicators.
This option can be disabled in MENU 6-1-4
On
Off
Flashing
Fast
On
Flashing
Flashing
Off
On
On
Off
Flashing
On
Off
On
Off
On
Off
On
Off
S4
On
Off
Off
Off
On
Red
Off
LED
Flashing
Off
On
Green
Off
LED
Flashing
Off
Red &
Green Flashing
Off
LED
Off
Table 7: ICON & LED Indicator Meanings
Meaning
The area is turned All On or Part On
The area is turned Off
The area has an alarm
System power is normal
System power is missing
A fire alarm is active
No fire alarm
Fire alarm in memory (Turn the area
All On and Off to Clear).
The existing service or trouble
condition has been acknowledged.
No service or trouble conditions exist
A service / trouble condition is present
that has not been acknowledged.
The area is turned Part On.
The area is not turned Part On.
The area is turned off.
The area is turned All On or Part On
The area is turned All On
The area is turned Off
You have mail waiting to be read
No Mail
Area is ready to turn on
(All On / Part On)
Not ready, Zone Open
All On
Alarm
Area is off.
Area not ready to turn on
Installer programming mode is active.
Bosch Security Systems 05/10 BLCC100I