NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked of bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, dont' pull at wire of connector. It is possible that a wire is snapped.
• When installing a connector, dont' press down at wire of connector.
It is possible that a wire is snapped.
DCR-HC27E/HC28/HC28E_L2
2. DISASSEMBLY
2-1
Cut and remove the part of gilt
which comes off at the point.
(Be careful or some
pieces of gilt may be left inside)