Table of Contents
Advertisement
xe) am Kellie
Talcelaaatciecelan
Precautions
Troubleshooting Guide
Maintenance
Specifications
Glossary
Index to Parts and
Controls
index
For Your Information
Se
ee
a
ee
Precautions
If you have any questions or problems
concerning your stereo system, please
consult your nearest Sony dealer.
On operating voltage
Before operating the stereo system, check
that the operating voltage of your stereo
system is identical with the voltage of your
local power supply.
110 — 120 V or
220—-240V AC
adjustable, 50/60 Hz
Operating voltage
On safety
The unit is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the
unit itself has been turned off.
¢ Unplug the system from the wall outlet
(mains) if it is not to be used for an
extended period of time. To disconnect
the cord (mains lead), pull it out by the
plug. Never pull the cord itself.
Should any solid object or liquid fall into
the component, unplug the stereo system
and have the component checked by
qualified personnel before operating it any
further.
«AC power cord must be changed only at
the qualified service shop.
*Do not open the disc tray during CD
operations. This activates the safety
device, stops operations, and starts
initializing operations.
On installation
Place the stereo system in a location with
adequate ventilation to prevent heat
build-up in the stereo system.
On condensation in the CD player
component
If the system is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may condense
on the lens inside the CD player. Should
this occur, the CD player will not operate.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.
To save a tape permanently
To prevent a tape from being accidentally
recorded over, break off the cassette tab
from side A or B as illustrated. If you later
want to reuse the tape for recording, cover
the broken tab with adhesive tape.
When you are using a TYPE II (CrO,)
cassette, be careful not to cover the
detector slots which allow the tape player
to automatically detect the type of tape.
Detector
slots
In case colour irregularity is
observed on nearby TV screens
With the magnetically shielded type of the
speaker system, the speakers can be
installed near a TV set. However, colour
irregularity may still be observed on the TV
screen depending on the type of your TV
set.
If colour irregularity is observed...
Turn off the TV set once, then turn it on
after 15 to 30 minutes.
If colour irregularity is observed
again...
Place the speakers farther away from the
TV set.
Se
ee
ee
Troubleshooting
Guide
If you run into any problem using the
stereo, use the following check list. And
first check the following points:
¢The power cord is connected firmly.
*The speakers are connected correctly and
firmly.
Should any problem persist after you have
made the checks below, consult your
nearest Sony dealer.
Tuner
"TUNED" flashes in the display.
=> Adjust the aerial.
"STEREO" flashes in the display.
=> Adjust the aerial.
Severe
hum
or noise.
=> Adjust the aerial.
> The signal strength is too weak.
Connect the external aerial.
=> Connect the ground wire.
A stereo FM programme cannot be
received in stereo.
=> Press STEREO/MONO
on the
remote commander so that
"STEREO" appears.
Advertisement
Table of Contents
