Playing A Tape - Sony FH-C33X Operating Instructions Manual

Playing a Tape
Recording a CD
[Re Se EE
Playing a Tape
You can use TYPE I (normal) and TYPE II
(CrO,) tapes.
When you insert the tape, the deck detects
the tape type automatically.
POWER—ON
= WN
DOLBY NR
1 Press 4 EJECT to open the tape
compartment.
Insert a recorded tape in deck A or B
with the tape side facing down. Push to
close the compartment.
2 Choose single-side, dual-side, or relay
play.
The DIRECTION mode setting affects
both decks.
To play Set DIRECTION to _
One side of the tape >=
Both sides* fase)
Both decks in RELAY
succession**
* The deck stops automatically after
repeating the sequence 5 times.
** See "To play both decks in succession
(relay play)."
3 Press [> (to play the front side) or <j
(to play the reverse side).
The tape starts playing.
To Press
Stop play |
Pause PAUSE [i on the
deck B
Resume play after PAUSE fl] on the
pause deck B or <Jor
a es
Fast forward pp for front side
44 for reverse side
Rewind 44 for front side
pp for reverse side
Remove the cassette EJECT
To play automatically after fast
winding (auto play)
To start playing from the beginning of the
front side, press [> while holding down
<<.
To start playing from the beginning of the
reverse side, press <q] while holding down
>>.
To play both decks in succession
(relay play)
Relay play always follows the following
sequence. When the reverse side of the tape
in deck B finishes playing, the following
sequence continues 4 more times.
Deck A
(Front side)
Deck B
Deck A
(Reverse side)
Deck B
<_
4
1 Press 4 EJECT and insert recorded tapes
in both decks.
2 Set the DIRECTION mode selector to
RELAY.
3 Press <Jor [> on either deck.
To stop relay play
Press gon the playing deck.
if you play both decks at the same time
You hear the sound from deck A.
However, a short break in sound output
will occur after the activation of the second
deck.
When listening to a tape recorded with the
Dolby* noise reduction system
Set the DOLBY NR switch to ON.
The setting affects both decks. Dolby noise
reduction system reduces tape hiss noise in
low-level high-frequency signals.
* Dolby noise reduction manufactured
under license from Dolby Laboratories
Licensing Corporation.
"DOLBY" and the double-D symbol 00
are trademarks of Dolby Laboratories
Licensing Corporation.
continue to next page >
Chapter 4: the Tape Player
EN