Taking Care Of Your Machine - Zanussi DI 720 Instructions For The Use And Care

Taking Care of Your Machine
Important
Make sure that the machine is unplugged
and the water turned off before
undertaking any kind of maintenance.
Please note, when moving house make
sure that the machine is not tilted too
much during transport.
General Cleaning
Inspect the filters and spray arm nozzles
before re-loading the machine and remove
any food scraps. Wipe round the rubber
gasket at the bottom of the door to
remove grease which tends to collect
there.
Cleaning the Filters
It is essential to clean the filter system
regularly. It can easily get clogged with
scraps of food which will cause the
machine to work inefficiently.
There are three filters (see fig. 15 below),
one large circular fin-mesh filter (A) and
two small cone-shaped ones (B & ©).
Inspect, and if necessary clean, the cone
shaped filters (C fits inside B) after each
wash cycle. Remove them both by turning
the outer one (B) clockwise until it
disengages or simply by lifting it up
according to the model. Then remove the
inner one (C) by squeezing the two plastic
tongues at the bottom of the outer filter
(B). Remove any food scraps and clean
thoroughly with a stiff saucepan brush
and hot sudsy water.
The large fine mesh filter (A) should be
thoroughly cleaned about every two
months. To remove the filter (A), first take
off the bottom spray arm by releasing the
securing catches and lifting it up. Unlock
the base of the spray arm (D) (fig. 15) and
then lift out the filter.
Clean it with a stiff aucepan brush and
hot sudsy water. Replace the filters and
the spray arm making sure that all the
parts are securely in position.
Important
Never use the dishwasher unless the
filters and spray arm are firmly in the
correct position.
21