Removing The Engine Guard (All Six Days Models, Exc Au); Installing The Engine Guard (All Six Days Models, Exc Au) - Husqvarna 125 XC-W 150 2017 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.46

Removing the engine guard (All Six Days models, EXC AU)

12.47

Installing the engine guard (All Six Days models, EXC AU)

–
Now inject the fluid into the system until it emerges from drill hole
ter cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir to prevent overflow.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
E00339-10
Info
Clean up overflowed or spilled brake fluid immediately with water.
–
Remove screws
H01638-10
–
Attach the engine guard on the frame at the rear and swing up at the front.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
H01638-10

and engine guard.
 .

4 mm (0.16 in)
M6 10 Nm (7.4 lbf ft)
75
of the mas-