Advertisement
HOOK-UP CABLES AND CONNECTORS
Most videolaudio
connections
between
components
can be made with shielded
video and audio cables that have phono
connectors.
For best performance,
video cables should use 75-Ohm coaxial shielded wire. Cables can be purchased from most
stores that sell audio/video
products.
Below are illustrations and names of common connectors,
Before purchasing any cables,
be sure of the output and input connector types required by the various components
and the length of each cable.
300-Ohm Twin Lead Connector
This outdoor antenna cable must be connected to an antenna
adapter (300_Ohm to 75-Ohm).
"F" Type 75-Ohm Coaxial Antenna Connector
For connecting
RF signals (antenna
or cable TV) to the
antenna terminal on the Rear Projection Television.
Phono Connector
Used on all standard video and audio cables which connect to
inputs and outputs located on the Rear Projection Television s
rear jack panel and front control panel.
D-SUB MINI 15-Pin Cable (Optional)
This cable is used to connect a computer VGA output to the D-
SUB input.
Optical
Cable
This cable can be used to connect to a component
with an
Optical Audio Out jack, such as a Dolby* Digital DVD player or
an HDTV Set Top Box. Use this cable for the best sound quality.
S-VIDEO (Super Video) Connector
(Optional)
This connector
is used on camcorders,
VCRs, and laserdisc
players with an S-VIDEO feature in place of the standard video
cable to produce a high quality picture.
2
3.5 mm
RCA Type
Stereo
_lugs
Mini pBug
Stereo Cable (3.5 mm plug to 3.5 mm plug) (Optional)
This cable is used to connect from AUDIO OUT jack on the
back of the computers
sound card to the PC AUDIO INPUT
jack of the Rear Projection Television.
ANTENNA CONNECTIONS
TO REAR JACK PANEL
VHF (75-Ohm) antenna/CATV
(Cable TV)
When using a 75-Ohm coaxial cable system, connect the outdoor
antenna or CATV coaxial cable to the ANT A (75-Ohm) terminal.
If
you have a second antenna or cable TV system, connect the coaxial
cable to the ANT B terminal.
VHF (300-Ohm) antenna/UHF
antenna
When using a 300-Ohm twin lead from an outdoor antenna, connect
the VHF or UHF antenna
leads to screws of the VHF or UHF
adapter.
Plug the adapter into the antenna terminal on the TV.
When both VHF and UHF antennas
are connected
Attach
an optional
antenna
cable
mixer
to the TV antenna
terminal,
and connect
the cables to the antenna mixer. Consult
your dealer or service store for the antenna mixer.
To outdoor antenna
or CATV cable
TO CONVERTER
11_
ANTB
TO secon6 antenna
or cable system
To outdoor VHF
or UHF anter_na
To outdoor
To UHF
ANT A/ANT B
antenna or
Antenna
II
CATV system
1"
Antenna
mi×et
7
Advertisement
