Cisco MDS 9700 Series Hardware Installation Manual page 41

Product Overview
17
18
19
20
The following table describes the LEDs on the Cisco MDS 9700 Series Supervisor-1E Module.
Table 4: Cisco MDS 9700 Series Supervisor-1E Module LEDs
LED
ID
Status
System
Active
Power Management
PWR MGMT: system power status LED
Management port operational status LED
Module ejection lever
Slot0 USB port
Status
Blinking blue
Off
Green
Red
Blinking Red
Off
Green
Amber
Red
Off
Green
Amber
Green
Amber
Cisco MDS 9700 Series Switches Hardware Installation Guide
Cisco MDS 9700 Series Supervisor-1E Module
Description
A user has activated this LED to allow a person to f
Location identification is deactivated for this modul
All module diagnostics passed. The module is opera
Indicates one of the following conditions:
• The module has detected an error and cannot p
• The module is not properly inserted.
• A bootup or runtime diagnostic test has failed.
Indicates one of the following conditions:
• An over temperature condition has occurred. (A
an environmental monitoring.)
• The module is resetting.
• The ejector lever is open.
The module is not receiving power.
All environmental sensors in the system are within
At least one power supply has failed or the power su
The temperature of the supervisor module exceeded
The slot has detected a slot ID parity error
The supervisor is operational and in the HA-active s
The supervisor module is in HA-standby state.
There is sufficient power available for all installed m
There is insufficient power for all installed modules
27