Controls And Indicators - Kenwood KR-V126R Instruction Manual

Controls and indicators
'@ POWER switch
Press this switch to turn on power. (The POWER STAND
BY indicator lights.) Press it again to turn power off.
@ SPEAKERS A and B switches
A,B OFF - This position silences all speakers to permit
private use of headphones.
A ON - Activates speakers connected to the SPEAKERS
A terminals on the rear panel.
B ON - Activates speakers connected to the SPEAKERS
B terminals on the rear panel.
A,B ON - Activates speakers connected to the SPEAK-
ERS A and B terminals simultaneously.
Note:
When the SPEAKERS A and B switches are used at the same time,
the speakers connected to the SPEAKERS A and B terminals are
connected in series. In this respect, whenever using the SPEAK-
ERS A and B switches at the same time, be sure that two pairs
of speakers are connected to the terminals A and B, otherwise no
sound is Output.
@ PHONES jack
Stereo headphones are plugged into this jack.
© EQ (Equalizer) PRESET keys
Use these keys to store equalizer curves in memory or to
recall them.
PGM: User-adjusted equalizer curves can be programmed
as desired and stored in memory; up to five patterns.
SET: Five factory-preset equalizer curves are stored in
memory.
Upto 10 equalizer curve memories are available in total.
Press the PGM/SET key to select either the user-
programmed pattern or the factory-preset pattern.
© Equalizer level controls
Adjust these controls up and down to equalize the sound
by +12 dB to the center frequency indicated.
10 kR-v126R/KR-V106R/KR-V8ER (K)
'OM/STANO BY
SPEAKERS
KENWOOD auoio-vineo sTeREO RECEIVER |«R-vidler
£0 |'sPi. PEA MOLD Cou
<ZEQ PRESENCE > <I REAR VOLUME >>
DECREASE INCREASE DOWN:
ro EQUALIZER =F p— SURROUND ——
ON/DIFEAT EQHEC
© 0008 00
@ EQUALIZER key
Press this switch to ON and the frequency characteristic
will be modified by passing through the graphic equalizer.
In the DEFEAT position, the frequency characteristic
remains unchanged.
@ EQ REC key
Used when recording the source onto the tape deck
through the equalized response of the graphic equalizer.
© EQ PRESENCE controls
Adjust these controls (INCREASE and DECREASE) to boost
or attenuate the equalizer curve indicated.
© PGM/SET key
Pressing this key alternates the preset equalizer curves to
be recalled between PGM (user-programmed patterns) and
SET (factory-preset patterns) groups.
@ Equalizer preset MEMORY key ;
This key is used to store an equalizer curve into the PGM
PRESET memories. First, select the desired equalizer curve
and then press this key. Then press any of the PRESET(A
to E) keys. The selected equalizer curve will be stored in
the memory indicated by the PRESET key pressed.
@® EQ/SPI key (KR-V126R/KR-V106R)
Pressing this key alternates the display mode between the
EQ (graphic equalizer) and SPI (spectram peak indicator-
spectrum analyzer).
@ PEAK HOLD ON/OFF key (KR-V126R/KR-V106R)
In the spectrum analyzer display (SPI) mode. pressing this
key activate or deactivate the Peak Hold function of the
power meter indicator.
ca aa Zo
uP ZO s-O