Advertisement
'
CONTRO LS, INDICATORS AND CONNECTORS
--
, ..
ee
90
92
9l:l
'J;
1 (.;
>or
1 )8
,. ,. ,
'T
•
.....
>C"
OCC
.. ()
<)00
•200
4 00
1'()0
""'
-
l-
--------------
------
---------------------------
0
0
0
f)
0
0
0
POWER switch
Turns the power to the unit on and off.
f)
PHONES jack
Stereo headphones are plugged into this jack.
8
SIGNAL indicators
These indicators show the relative signal levels of incoming
broadcasts
For best reception. both the FM and AM anten-
nas shou ld be installed so that both the LOW and HIGH
lamps will light.
8
BASS and TREBLE controls
Turn
clockw1se to
increase
bass or treble response.
counterclockwise to
reduce
bass or treble response.
Response is flat w hen set to the center.
0
SPEAKERS switches
A. B OFF -
Silences all speakers to permit private use of
headphones.
A ON - Activates speakers conn ected to the SPEAKERS
[6]
terminals on the rear panel.
B ON - Activates speakers co nnected to the SPEAKERS
lliJ
terminals on the rear panel.
A , B ON -
Activates speakers connected to the SPEAKERS
0
and
[ill
terminals simultaneou sly.
0
BALANCE control
This control permits balancing of left and right channels
when an imbalance exists in the sound source. or to correct
acoustic 1mbalance due to room cond it ions. Turn it to the
left from the center position to boost the left channel; turn it
to the right of center to raise the level of the right channel.
f)
LOUDNESS switch
This switch boosts bass response to compensate for the lack
of response
tn
human hearing to t hose frequ encies at low
volume levels. This switch should be switched off when
listening at normal and high levels.
0
VOLUME control
0
STEREO indicator
With the FM MODE switch set to AUTO the lamp lights to
indicate that the selected station is broadcasting in stereo. It
out for monaural broadcasts and when the FM
MODE switch is set to MONO.
CID
FM MODE switc h
AUTO -
Th e receiver switches automatically between
stereo and monaural operation in accordance with the
manner in wh ich the selected station is operating. And
thi s position is applied to silence int erstat ion noise
when tuning. To rece ive very weak stations. stations
that are too weak to overcome the muting threshold.
push in to d isable muting (MONO).
MONO -
Provides monaural operation regardless of the
transmitting mode.
SELECTOR switch
FM -
For recept ion of FM broadcasts.
A M -
For reception of AM broadcasts.
0
Input selector switches
TAPE A - Push this button to select input from a tape deck
connected to the TAPE A jacks.
TAPE B PLAY/ AUX - Push th1s button to select input from
a -component connected to the TAPE B PLAY/AUX
jaCks. or to dub from a tape deck
to the
TAPE B PLAY
I
AUX jacks to a tape deck connected to
TAPE A jacks.
TUNER -
Push this button to listen to broadcasts.
PHONO -
Push th1s button to select input fro m a t urntable
connected to the PHO NO jacks.
Note: ------------------------------------------
The input selector switch has priority. The order of priority is TAPE
A. TAPE B PLAY/AUX and TUN ER or PHONO. For example. when
the TAPE A. TAPE B PLAY/AUX and TUNER indicators light yellw.
TAPE A has priority.
G) Input selector indicator s
These indicators tu m from green to yellow w hen the cor-
respoding input selector switches are pressed.
This control adjusts left- and right-channel
vol ume
CD
TUNING knob
Simultaneously. Set it for the destred listening level.
AM and FM statio ns are selected by tuming this kn ob.
4
KR-65 (K)
Advertisement
