Advertisement
CHANGING THE CUTTER
BLADES (See Figure 9)
WARNING: Do not change cutter
blades without gloves.
In order to change the cutter blades it
is necessary to lock the cutter disc by
placing the flat wrench through the
slot in the casing and cutter disc, so
that the blade can not rotate.
The cutter blades are initially sharp on
both edges. The second edge can be
used by removing the two Allen head
screws and rotating the blade
horizontally 180 degrees then
retighten the screws.
Remove flat wrench before replacing
cover and tightening cover screw. If
necessary, a new set of cutter blades
(Cat. NO. 682044) can be obtained at
any Black & Decker Service Center.
CHANGING THE PRE-CUTTER
BLADE (See Figure 10)
WARNING:
Do not change pre-cutter
blade without gloves.
In order to change the pre-cutter
blade, it is necessary to iock the
cutter disc by placing the Alien wrench
through the siot in the casing and
cutter disc. The disc must then be
rotated CLOCKWISE until it locks up.
Then loosen the nut CLOCKWISE.
Remove the pre-cutter and replace it
with a new one (Cat. No. 918224)
obtained from your Black & Decker
Service Center. Position the
pre-cutter blade 90° to the cutting
blades. Tighten nut COUNTER
CLOCKWISE.
Remove Allen wrench before
replacing cover and tightening screw.
Advertisement
