Communications Diagnostics
Test Communication - Performs network diagnostics and sends test alarms to the network. The following tests are
available depending on the type of communications module installed.
Setup Communication – Registers the LYNX Touch and its associated communication module, update configuration files
Register Device With PIN:
WiFi Stats – Displays WiFi Specific Diagnostics information (Not intended for Installer use)
Message
Send Cellular Message:
Test Ethernet:
Send Ethernet Message:
Send Any:
or reset factory defaults.
Selection
Download Config File:
Register Device:
Update Server:
Factory Defaults:
Function
Available if Cellular communication path is enabled
Available if IP or WiFi communication path is enabled
Available if IP or WiFi communication path is enabled
Available if IP or WiFi and Cellular communication path is enabled
Function
The device configuration file will be downloaded
Registers the module with AlarmNet
Used enter PIN when replacing one module with another
The communication device uploads its configuration to the server
The communication device is reset to factory default values
- 19 -