Pioneer PL-514 Operating Instructions Manual page 3

-—Counterweight
Slide the counterweight
onto the counterweight
shaft at the rear end of
the tonearm and turn it
3 to 4 times in a clock-
wise direction.
Dust cover:
When removing the dust
cover, first open it all the
way, hold the lower part of }
the dust cover from behind,
and lift it straight up.
Platter mat
ZZ
Phono cables
Drive belt
Motor pulley:
|
Ll
Ground lead
round le
Belt guide
Si
2
SZ
Center shaft
ANTI-SKATE knob
Headshell
Align the guide pin with the groove as
shown in the figure and secure by turn-
ing the locking collar
ARM-ELEVATION lever
Arm rest
'SPEED select lever
Fig. 4
HOW TO ATTACH THE DRIVE BELT Ribbon
Set the platter down over the center shaft. Next, ee
set the SPEED select lever to the "33" position.
Motor pulley
\
Pulling the ribbon attached to the drive belt, pass
the belt through the belt guide and around the
smaller diameter (the upper portion) of the motor
pulley (Fig. 5).
After the belt has been properly positioned on the
motor pulley, remove the ribbon and place the .
platter mat.
Belt guide Drive belt -
Fig. 5