Table of Contents
Advertisement
D. MORSE TAPER DRILL BITS
To use Morse Taper Drill Bits, you must remove the chuck and taper (See Page 11). Place
the tapered bit into the spindle hole, push upward and twist until the bit is snug. Place a block
of wood between the bit and the table then crank the table upward until the bit is firmly in place.
Be sure the spindle taper and arbor are completely free of grease and dirt.
E. QUILL ADJUSTMENT
On the front of the head casting are three cap screws. These are adjusted at the factory to
minimize the play between the head casting and the quill. Grasp the chuck and move it from
side to side. Note the play between the quill and the head casting. Too much play will result
in inaccurate drilling operations while too little play will restrict the movement of the quill.
To adjust:
1. Loosen the two screws on the left.
2. Turn the screw on the right counterclockwise to reduce the play and clockwise to increase
the play. This adjustment should be minor-1/* turn at most.
3. Tighten the two screws on the left and test the play. Lower the spindle and release the
handle-it should return to the full up position. Re-adjust if necessary.
F. TABLE ADJUSTMENTS
FIGURE 11
1.
To adjust table up or down, loosen column lock handle and turn crank
handle to desired height. Re-tighten column lock handle (See Figure 11).
-
17
-
Advertisement
Table of Contents
