Packing List; Installing Sandpaper; Assembly - Craftsman 315.27984 Operator's Manual

UNPACKING
Thisproduct hasbeen shipped c ompletely assembled.
• Carefullyremove the too[ and any accessories from the
box. Make sure that a_litems listed in the packing mist
are inc)uded.
• Inspect the too[ carefullyto make sure no breakageor
damage occurred during shipping.
• Do not discard the packing materis[ untilyou have
carefullyinspected and satisfactorilyoperated thetool.
• If any parts are damaged or missing, please call
1-800-932-3488 for assistance.
PACKING LIST
Sander
Dust Bag
Paper Punch
Sandpaper (1)
Operator'sManual
_k WARNING" If any parts are missingdo not operate
thLstool untilthe missing parts are repracsd, Failure
to do so could result in possiblessr[ous persosai
injury.
_ WARNING: Do not attempt to modify this tool
or create accessoriesnot recommended for use
with this tool. Any such atterat(on or modification Ls
misuse end could result in e hazardouscondition
feadiog to possibleserious persona[In}ury.
A WARN|NG: Do not connect to power supply until
assembly is complete, Failureto comply could result
in accidental startingand possibleseriousinjury.
_k WARN|NG: Do not allow familisrity with tools
to make you careless. Rememberthat a careless
fraction of a second is sufficientto inflictserious
injury.
_L WARNING: Always wear safety gogglesor safety
glasses with side shieldswhen operating power
tools, Failureto do so could rseultin objectsbeing
thrown into your eyes resultingin possibleserious
injury.
INSTALLING SANDPAPER
The cushionon the sander gives you the option of using
either non-adhesive sandpaperthat clamps to the platen
or adhesive backed sandpaper with pressuresensitive
adhesive backing that sticks to the cushion.
INSTALLING NON-ADHESIVE SANDPAPER
See Figure2.
• Unplug the sander.
• inspect sandpaper before installing.Do not use if bro-
ken or defsc_ve.
• If rap{acingsandpaper, remove old sandpaper. To
remove paper, release paper clamp by lifting up on
lever and disengagingit from the tab on the platen.
• Insertend ofnew 1/4sheet sandpaper approximately
(1/2 inch) under the paper clamp.
• Lift up on paper clamp (everand lock into p(ace. Apply
downward pressure to conform sandpaper to p(atan.
• Wrap sandpaper around cushion.Lift lever on opposite
end of sander and insertloose end of sandpaper under
the paper clamp. Fit sandpaper againstcushionas
fight as possible.
• Lift up on paperclamp lever and lock _nto place.
CUSHION
NON-ADHESIVE
SANDPAPER
PAPER
CLAMP Fig. 2
LEVER