Summary of Contents for Breville Power Blender BLR50
Page 1
Breville is a registered trademark of Breville Pty. Ltd. A.B.N. 98 000 092 928. Copyright Breville Pty. Ltd. 2014. Due to continued product improvement, the products illustrated/photographed in this book may vary slightly from the actual product.
Page 2
the Power Blender ™ Instruction Booklet Suits all BLR50 and BBL300 models...
BREvILLE RECoMMENDS SAFEty FIRSt We design and manufacture our products with your safety foremost in mind. We ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions. IMPoRtANt SAFEguARDS the appliance in a safe way,...
Page 4
• Do not operate appliance with a damaged cord or plug, or after appliance malfunctions, or if dropped or damaged in any way. Stop use immediately and contact Breville by phone or email for replacement or repair.
Page 5
PAge heAder..BREvILLE RECoMMENDS SAFEty FIRSt SAFEguARDS FoR • Keep hands, fingers, hair youR BLENDER and clothing away from the blender during use. Always • Wash the blender jug with turn blender off and unplug warm soapy water before at the wall before reaching first use.
Page 6
PAge heAder..BREvILLE RECoMMENDS SAFEty FIRSt • Never blend hot liquids. Allow ingredients and liquids to drop to room temperature before putting into the jug for blending. • Do not put the blender jug in extremes of heat or cold,...
PAge heAder..KNoW youR BREvILLE PRoDuCt Inner measuring cup Speed control dial with 5 speeds and pulse 1.5 litre glass jug Non-slip feet Serrated ice-crushing stainless steel blades...
BREvILLE PRoDuCt uSINg tHE BLENDER • Ensure the speed selection dial is in the • SPEEDS 1-2: Suitable for savoury dips, ‘0’ position. Insert the power cord into a thin batters and soups. 230/240V power outlet and switch on.
Page 9
BREvILLE PRoDuCt DISASSEMBLINg BLADES FRoM Jug Turn the jug upside down. The inner measuring lid doubles as a blade assembly tool. Insert the tabs on tool into the grooves on the blade assembly. Remove the silicon seal, and keep it safe for re-assembly.
Page 10
PAge heAder..oPERAtINg youR BREvILLE PRoDuCt RE-ASSEMBLINg BLADES to Jug Place the silicone seal onto the narrow end of the blender jug so that the seal sits underneath the 3 tabs. Carefully insert the blade assembly. The inner measuring lid doubles as a blade assembly tool.
PAge heAder..CARE, CLEANINg & StoRAgE Jug and lid Cleaning agents In order to keep your jug clean and avoid Do not use abrasive scouring pads or food drying on the blades and jug, follow the cleaners on either the motor base or the jug, below steps as soon as possible after use: as they may scratch the surface.
HINtS & tIPS HINtS & tIPS Do’S AND DoN'tS • If the volume (while blending) is below the Do’s the maximum line, the inner measuring • Use a combination of the blending and cap can be removed and oils/liquids can pulse to suit the foods being processed.