Download Print this page

Usb Charging Port; Maintenance - AEG A18DSR Original Instructions Manual

Advertisement

• To disconnect the current device to allow connection to another
BLUETOOTH enabled device, press and hold the BLUETOOTH
button for 3 seconds. The radio will then be in pair mode and can
be connected to a different device.
NOTE: The product will turn off in half an hour if no audio has been
streamed in BLUETOOTH mode. Turn on the product to resume
operation.
AM/FM button
Press the AM/FM button to enter AM or FM mode.
Arrow buttons < >
In BLUETOOH mode: Press the arrow buttons on the radio to go to
the previous or next track.
In radio mode: Press the left arrow button to tune to a lower
frequency. Press the right arrow button to tune to a higher
frequency. Briefly push either button (not press and hold) to tune
one frequency step at a time. Press and hold the desired arrow
button for one second to tune to the next frequency with clear
reception.
PRESETS button
The memory feature saves up to 20 frequencies as presets in the
radio's memory. You can save 10 frequencies in FM mode and 10
in AM mode.
To store a frequency in memory:
• Tune to the frequency you want to save.
• Press and hold the PRESETS button for 1 second. A memory
location number will blink on and off.
• Press either arrow button to scroll through the preset positions.
• Press the PRESETS button to store the frequency in the selected
memory location.
To recall a preset frequency:
• Press the PRESETS button and quickly release to cycle through
stored frequencies.
In BLUETOOTH mode, press the PRESETS button to play/pause
streamed audio.
Volume up button +
Use the volume up button to increase volume.
Volume down button -
Use the volume down button to decrease volume.

USB CHARGING PORT

Connect a USB device to the USB charging port to get power from
the product. When the product is turned off, USB charging port can
charge device for 1 hour.

MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to various types of commercial solvents and may
be damaged by their use. Use clean cloths to remove dirt, carbon
dust, etc.
Use only AEG accessories and spare parts. Should components
that have not been described need to be replaced, contact one
of our AEG service agents (see our list of guarantee/service
addresses).
If needed, an exploded view of the product can be ordered. State
the product type and the serial number printed on the label, and
order the drawing at your local service agents or directly at:
Techtronic Industries Australia Pty Ltd
PO Box 1065
Mount Waverley VIC 3149
Tel. no. 1300 234 797
Australia
Techtronic Industries N.Z. Limited
PO Box 12-806
Penrose AUCKLAND 1642
Tel. no. 0800 234 797(0800 AEGPWR)
New Zealand
SYMBOLS
Read the instructions carefully before starting the
product.
CAUTION! WARNING! DANGER!
For indoor use only
V
Volts
Direct current
Regulatory Compliance Mark (RCM). Product meets
applicable regulatory requirements.
Bluetooth
Do not dispose of waste batteries, waste electrical
and electronic equipment as unsorted municipal
waste.
Waste batteries and waste electrical and electronic
equipment must be collected separately.
Waste batteries, waste accumulators, and light
sources have to be removed from the equipment.
Check with your local authority or retailer for recycling
advice and collection point.
According to local regulations, retailers may have an
obligation to take back waste batteries and waste
electrical and electronic equipment free of charge.
Your contribution to the reuse and recycling of
waste batteries and waste electrical and electronic
equipment helps to reduce the demand of raw
materials.
Waste batteries, in particular containing lithium, and
waste electrical and electronic equipment contain
valuable and recyclable materials, which can
adversely impact the environment and the human
health if not disposed of in an environmentally
compatible manner.
Delete personal data from waste equipment, if any.
9

Advertisement

loading