Cisco Nexus 9348GC-FX3PH Hardware Installation Manual page 8

Overview
• Power supply modules (two—one for operations and one for redundancy [1+1]) with the following
choices (a mix of AC and DC power sources is supported but do not mix airflow directions):
• 350-W AC power supply with port-side intake airflow (burgundy coloring) (NXA-PAC-350W-PI2)
• 350-W AC power supply with port-side exhaust airflow (blue coloring) (NXA-PAC-350W-PE2)
• 1900-W AC power supply with port-side intake airflow (burgundy coloring) (NXA-PAC-1900W-PI)
• 1900-W AC power supply with port-side exhaust airflow (blue coloring) (NXA-PAC-1900W-PE)
Note The following power levels are available for AC power supplies; 1900W, and
350W with the below load configurations. The PoE configurations and minimum
power supply requirements are noted below as well:
The following figure shows the switch features on the port side of the chassis.
1 LEDs
3 QSFP28 ports (2)
5 10M/100M RJ45 ports (8)
To determine which transceivers, adapters, and cables are support this switch, see the
Modules Compatibility Information
The following figure shows the switch features on the power supply side of the chassis.
Cisco Nexus 9348GC-FX3PH NX-OS Mode Switch Hardware Installation Guide
2
• 48 PoE++ (60W ports) - two 1900W power supplies needed.
• 21 PoE++ (60W ports) - one 1900W power supplies needed.
• Non-PoE - one or two 350W power supplies needed.
document.
2 SFP28 ports (4)
4 10M/100M/1G RJ45 ports (40)
Overview
Cisco Transceiver