Removing The Temporary Stand; Stand Hole Protection Cover - Sharp PN-S655 Operation Manual

Removing the Temporary Stand

Prepare wall-hanging brackets or a stand to mount the monitor unit. Read the manual for the brackets or stand for the proper
mounting procedure. (The screw holes for mounting brackets (M10 x 4 holes) are provided on the rear of the monitor.)
Caution
• The monitor is heavy. Make sure to handle the monitor with at least 2 people.
• This monitor is fixed to the temporary stand when shipped from the factory. Please note that this stand is for temporary use
only until the monitor is properly mounted.
• The temporary stand is specifically designed for this monitor. Do not use for other devices.
1. Hold the monitor with the handles to prevent it
from falling down, and remove the stand fixing
screws (4).
2. Lift the monitor by holding it with the handles and
the underside of the unit.
3. When the installation is complete, attach the
included stand hole protection covers, using the
supplied screws.
(1) Fold the sheet perpendicularly with the
adhesive side inward.
(2) Remove the adhesive cover and attach the
sheet to the monitor.
Screws Screws
1
2
13
E