HIKVISION DS-K3G200X Series Manual page 73

Configure Parameters for Door/Elevator
After adding the access control device, you can configure its access point (door or floor)
parameters.
Before You Start
Add access control device to the client.
Steps
1. Click Access Control → Advanced Function → Device Parameter .
2. Select an access control device on the left panel, and then click
the selected device.
3. Select a door or floor to show its parameters on the right page.
4. Edit the door or floor parameters.
Note
The displayed parameters may vary for different access control devices.
●
Some of the following parameters are not listed in the Basic Information page, click More to
●
edit the parameters.
Name
Edit the card reader name as desired.
Exit Button Type
You can set the exit button as remaining closed or remaining open. Usually, it is remaining
open.
Open Duration
The door contact can be enabled with appropriate delay after person with extended access
needs swipes her/his card.
5. Click OK.
6. Optional: Click Copy to , and then select the door/floor(s) to copy the parameters in the page to
the selected doors/floor(s).
Note
The door or floor's status duration settings will be copied to the selected door/floor(s) as well.
Configure Parameters for Card Reader
After adding the access control device, you can configure its card reader parameters.
Before You Start
Add access control device to the client.
DS-K3G200(L)X Series Tripod Turnstile
62
to show the doors or floors of