Next steps
1. Install the
3-cell battery
2. Install the
wireless
card.
3. Install the
base
cover.
4. Follow the procedure in
Touchpad
Removing the touchpad
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
3-cell battery
About this task
The following images indicate the location of the touchpad and provide a visual representation of the removal procedure.
Steps
1. Peel the tape that secures the touchpad to the palm-rest and keyboard assembly.
2. Open the latch and disconnect the touchpad flexible flat cable from the connector on the system board.
3. Remove the two screws (M2x2) and the four screws (M1.6x2.5) that secure the touchpad to the palm-rest and keyboard
assembly.
4. Lift the touchpad, along with the touchpad flexible flat cable, off the palm-rest and keyboard assembly.
58
Removing and installing Field Replaceable Units (FRUs)
or the
4-cell
battery, whichever applicable.
After working inside your
Before working inside your
or the
4-cell
battery, whichever applicable.
computer.
computer.