Breville BRITA HotCup Manual page 4

PREPARING THE BRITA MAXTRA+
®
1. Remove the cartridge from its wrapping (it is normal for the
cartridge to appear moist during storage).
2. Immerse the cartridge in cold tap water and shake gently to
remove any air bubbles. There is no need to pre-soak this
cartridge before use.
3. Lift the complete lid off your HotCup
remove the filter funnel. Insert the cartridge into the filter
funnel and push it firmly into place. When correctly fitted,
the cartridge should remain in place when the funnel is
turned upside-down.
4. Fill the filter funnel with cold tap water up to the MAX mark
and allow it to filter through discarding the water. Repeat
this process, again discarding the water.
5. The BRITA MAXTRA+ cartridge is now ready for use.
® ®
You do not need to keep the filter cartridge immersed in
water. Refit the filter funnel and filter into your HotCup
water dispenser. Replace the lid.
6. Always make sure that you have spare MAXTRA+
cartridges to hand. When buying new cartridges look for
the BRITA MAXTRA+ logo on the cartridge packaging.
® ®
7. When it is time to replace the BRITA
filter cartridge after 4 weeks use, simply grip the top
of the cartridge and pull upwards to remove. BRITA
cartridges are 100% recyclable. Visit www.brita.co.uk or
call the BRITA Care team on 0344 742 4800 for further
®
information on participating retailers.
8. Repeat steps 1-5 with a new cartridge.
6
VKJ367_22EM1 (UK).indd 6-7 VKJ367_22EM1 (UK).indd 6-7
CARTRIDGE
®
™ water dispenser and
™
®
MAXTRA+
® ®
®
USING THE BRITA MEMO FUNCTION
®
It is important to change your BRITA filter cartridge regularly to
®
enjoy the benefits of BRITA ® filtered water. Filtering your water
improves the look and taste of hot drinks by reducing limescale,
chlorine, metals and other impurities.
The BRITA ® Memo automatically reminds you when your
filter cartridge needs to be changed. BRITA
exchange the MAXTRA+ cartridge every 4 weeks.
®
When you have fitted and prepared your filter cartridge, start the
Memo as follows:
1. Press and hold the START button until 4 bars appear on the
display and flash twice. The Memo is now set.
2. The flashing dot in the corner of the display indicates that
the Memo is working.
3. Every week, one bar will disappear to indicate the remaining
cartridge life. When only one bar is showing, check that you
have a replacement filter cartridge available.
4. After 4 weeks, all four bars will disappear and a flashing
arrow will appear to indicate that the cartridge should be
replaced.
Wash and dry the filter funnel, insert a new cartridge and restart
the Memo as described above.
Please note that the Memo is only intended to be used with
BRITA ® filter cartridges.
More information on the use of BRITA water filter cartridges
®
and the Memo can be found in the BRITA
®
recommend to
®
information guide.
3/3/2022 2:44:43 PM 3/3/2022 2:44:43 PM
7