Table of Contents
Advertisement
Installing the power connector port
1
Insert the power connector port into the slot on the computer.
2
Route the power connector port cable through the routing channels.
3
Connect the power connector port cable to the connector on the system board.
4
Tighten the screw to secure the power connector port to the computer.
5
Install the:
a
display cable
b
palmrest
c
keyboard
d
hard drive assembly
e
base cover
f
battery
6
Follow the procedure in
Removing the system board
1
Follow the procedure in
2
Remove the:
a
battery
b
base cover
c
hard drive assembly
d
WLAN card
e
memory
f
keyboard
g
palmrest
h
display cable
i
system fan
3
To remove the system board:
a
Disconnect all the cables from the connectors on the system board.
b Remove the screw that secures the system board to the computer [1].
c
Lift and remove the system board from the computer [2].
20
Removing and installing components
After Working Inside Your
computer.
Before Working Inside Your
Computer.
Advertisement
Table of Contents
