Advertisement
Available languages
Available languages
CARTON
CONTENTS
Check carton contents
against the foF
lowing list,
Model 0944.511572
• Edger attachment
• Handlebar
• Handlebar mounting bracket for 1"
(2.5 cm) shaft
• Handlebar mounting bracket for 7/8"
(2.2 cm) shaft
• Bracket cover (2)
• Handlebar bracket screws (4)
• Attachment
Hanger
• Hex Wrench
Examine
parts for damage.
Do not
use damaged
parts.
NOTE: If you need assistance
or find
parts missing or damaged,
call
1-800-235-5878.
ASSEMBLY
_WARNING:
If received
as-
sembled,
repeat all steps to ensure
_/aOUr u nit is properly assembled
and all
steners are secure.
• A hex wrench
(provided)
is required
for assembly,
HANDLEBAR
ASSEMBLY
DANGER:
RISK OF CUT, To
avoid serious
injury, the barrier portion
of the handlebar
must be installed as
shown on the upper shaft of the pew-
erheed to provide a barrier between
operator
and the spinning
blade.
At-
tach handlebar
mounting
bracket
above arrow on safety warning
decal
on the upper shaft (pewerhead
end of
unit).
Ensure handlebar
is positioned
on mounting
bracket at the end of the
arrow on the handlebar
decal,
NOTE:
Two mounting brackets are in-
cluded with this attachment.
Both brack-
ets are provided to adapt this attach-
ment for use with powerheads
that have
either a 1" (2.5 cm) diameter or a 7/8"
(2.2 cm) diameter upper shaft. The cor-
rect bracket must be used to ensure
that the handlebar is mounted securely
to the upper shaft before use,
Handlebar _.
_ _-_ Screw
_
Bracket Cover
Mounting
_.._
Bracket
,'
!
1. Place the mounting
bracket over
the upper shaft above the arrow on
the safety label. Be sure to use the
correct mounting bracket for either
the 1" (2.5 cm) or 7/8" (2.2 cm) di-
ameter upper shaft.
2. Position one of the bracket covers
under the upper shaft and align the
mounting
bracket and the bracket
cover screw holes. Insert two
screws into the screw holes.
3. Secure the mounting
bracket by
tightening
the screws with the hex
wrench.
4. Locate the decal on the handlebar.
This decal includes an arrow. Posi-
tion the handlebar
with the mount-
ing bracket at the end of the arrow.
5. Position the second
bracket cover
over the handlebar.
Align the
mounting
bracket and the bracket
cover screw holes. Again make
sure the handlebar
is at the end of
the arrow.
6. Insert two screws and hand tighten
only. Be sure the handlebar
is
installed correctly;
then, tighten
each screw securely
with the hex
wrench.
6
Advertisement
