Getting Started; Setting Up To Connect To The Base Station - Sony LF-B20 Settings Manual

Getting Started

Setting Up to Connect to the Base Station

This section describes the setup for using NetAV to watch TV at home.
Preparing the Base Station
For details about preparing the Base Station for use, refer to the Quick Start Guide or Operating
Instructions document supplied with the Base Station.
Press the POWER button on the front
panel of the Base Station to turn it on.
The POWER LED on the front panel of the Base
Station will light up green.
• Check that the Base Station is connected
properly to a TV antenna. (LF-PK1/LF-X11
only)
• Check that the external devices are connected
properly to the audio/video input plugs of the
Base Station.
• Check that the IR Blaster is connected properly
to the IR BLASTER port on the Base Station,
and make sure the IR Blaster is positioned so
that it faces the IR Receiver of the external
device correctly.
LF-PK1/LF-X11
LF-B20/LF-B10
WIRELESS
NETWORK
SETUP MODE/
NET AV
SETUP MODE
RESET
6
POWER
LED
WIRELESS
NETWORK
SETUP MODE/
NET AV
SETUP MODE
RESET
POWER
LED