Replacing Boards; Figure 3.25 Turning The Cabinet Power Off; Figure 3.26 Removing Cable - Samsung OfficeServ 7200 Installation Manual

3.5 Replacing Boards

If the OfficeServ 7200 fails to operate normally due to an error on the power supply board,
control board, or interface board, replace the board to a new one.
Removing Cables
Replace a board after removing all cables connected to the board.
The procedure for replacing a board mounted in a slot of a cabinet is as follows:
1) Turn off the power of the cabinet.
2) When replacing a control board, first, remove the extension cable connecting the
MP20 to the LCP. Also, remove all cables connected to the board to be replaced.
© SAMSUNG Electronics Co., Ltd.

Figure 3.25 Turning the Cabinet Power Off

LINK1
LINK3
LINK2

Figure 3.26 Removing Cable

OfficeServ 7200 Installation Manual
3-29