Checking The Free Travel Of Foot Brake Lever - Husqvarna FE 250 Owner's Manual

13.7

Checking the free travel of foot brake lever

Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear
brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
–
Correct the brake fluid quantity to level
Guideline
A
Level (brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position cover
–
Mount and tighten screws
Info
Clean up overflowed or spilled brake fluid immediately
with water.
H03718-10
–
Disconnect spring
–
Move the foot brake lever back and forth between the end
stop and the contact to the foot brake cylinder piston and
check free travel
Guideline
Free travel at foot brake
lever
» If the free travel does not meet specifications:
402026-10
–
Adjust the basic position of the foot brake lever.
( p. 92)
–
Reconnect spring
BRAKE SYSTEM 13
A
.
5 mm (0.2 in)
p. 145)
2 3
with membrane .
1
.
1
.
A
.
3 ... 5 mm (0.12 ... 0.2 in)
1
.
91