Attaching A Cs-Mount Lens; Attachment Of The Auto-Iris Lens Connector (Optional); Detaching The Lens - Sony IPELA SNC-CS10 User Manual

Attaching a CS-mount
Lens
Suitable lens
The lens must be a CS-mount type of less than 1 kg (2 lb
4 oz). The protrusion behind the mounting surface must
be 4 mm (3/16 in.) or less.
When you use the C-mount lens, use the C-mount adaptor
(optional).
When you use the auto iris lens with this camera, use a DC
servo type lens.
CS-mount lens
4 mm (3/16 in.)
or less
Caution
When you install it into a wall or a ceiling, check that the
wall or the ceiling is strong enough to hold the weight of the
camera including the mounting bracket, and install it without
fail. If not, the camera falls down and causes a serious injury.
Also, check if the mounting is not loosened at least once a
year. Make the checking interval short according to use
condition.
Attachment of the auto-iris lens
connector (optional)
To connect the auto iris lens, first replace the plug on the
lens cable with a plug that fits the LENS connector (not
supplied).
When you use the auto-iris lens, you need to attach the
lens connecter (optional).
To attach it, request for a technical expert who has been
trained in services.
The lens connecter is optional and is not included with
the camera.
1
Detach the old plug from the lens cable.
2
Solder the wires of the lens cable to the pins of the
plug, and attach the cover (optional).
For cable pin assignment, refer to the instruction
manual of the lens.
1
8
7
6
5
1 Cover
2
Lens cable
3
Rib (If the cable is thick, cut this off.)
4
Plug (not supplied)
5
Pin 4 DC control
6 Pin 2 DC control
7
Pin 1 DC control
8
Pin 3 DC control

Detaching the Lens

2
1
Disconnect the lens cable from the auto iris lens
connector.
2
Turn the lens counterclockwise to detach it from the
camera.
2
3
4
Drive - (Ground)
Control +
Control –
Drive +
1

Attaching a CS-mount Lens

73