Dynamic Ip Address Notification Tab - Notifying The Ip Address - Sony IPELA SNC-CS10 User Manual

Re-type password
To comfirm the password, re-type the password typed in
the password box.
Obtain DNS server address automatically
Select to obtain the address of DNS server
automatically.
Use the following DNS server address
Select to set the fixed address as the IP address of DNS
server.
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server, if
necessary.
OK/Cancel
See "Buttons common to every menu" on page 28.
Dynamic IP address notification
Tab — Notifying the IP Address
When the DHCP setting is set to On or PPPoE setting is
set to On on the Network tab, you can send notification
of the completion of the network settings using the
SMTP or HTTP protocol.
e-Mail (SMTP) notification
Select On to send an e-Mail when the DHCP setting is
completed.
SMTP server name
Type the name or IP address of the SMTP server to use
for sending an e-Mail, up to 64 characters.
Authentication
Select the authentication required when you send an e-
mail.
Off: Select if no authentication is required when an e-
mail is sent.
On: Select if authentication is required when an e-mail
is sent. Select one of the authentication methods
from the following and specify the POP server
name, User name and Password as required.
SMTP: Select when SMTP authentication is
required.
POP before SMTP: Select when POP before SMTP
authentication is required.
Note
When you set Authentication to On, make sure to select
either or both SMTP or/and POP before SMTP.
POP server name
It is necessary when the POP before SMTP is selected
in Authentication.
Type the POP (receiving mail) server name up to 64
characters. Or type the IP address of the POP server.
This setting is necessary when the SMTP server which
sends e-Mails performs authentication using the POP
user account.
User name, Password
Type the user name and Password of the user who has
the mail account. This setting is necessary when the
SMTP server which sends e-Mails performs
authentication.
Recipient e-Mail address
Type the recipient e-Mail address up to 64 characters.
You can specify only one recipient e-Mail address.
Administrator e-Mail address
Type the e-Mail address of the camera administrator, up
to 64 characters. This is used as the reply address or the
address for a system mail from the mail server.
Subject
Type the subject/title of the e-Mail up to 64 characters.
Message
Type the text of the e-Mail up to 384 characters. (A line
break is equivalent to 2 characters.) You can describe
the information of the acquired IP address, etc. using the
special tags mentioned below.
Configuring the Network — Network Menu
39