Starting Your New Freezer - Black & Decker BCFK356 Instruction Manual

ENGLISH
SET UP & USE
PROTECTION FROM HEAT AND MOISTURE
• Do not install your freezer in any location where heavy moisture is present or if
the location is not properly insulated. This freezer is not designed to operate in
temperature setting below 55°F.
• Location for the freezer should be on a hard surface and away from direct sunlight
and heat source, e.g., radiators, baseboard heaters, cooking appliances, etc.

STARTING YOUR NEW FREEZER

1. After cleaning your freezer thoroughly, wipe the outside with a soft dry cloth, the
interior with a clean moist cloth.
2. Insert the power supply cord into the electrical outlet.
3. Turn the thermostat dial to an initial setting of "7" for 24 hours and then set the
freezer to your desired setting.
NOTE: As the door gets pressed in during shipping, the gasket may have to be reset.
This is done to prevent the cool refrigerated air from escaping. If there is a gap
between the door gasket and the cabinet, set the gasket by gently pulling it
out of the seal gap.
Page 8