Thermal sensor
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To remove or install the thermal sensor, do the following:
1. Prepare your computer. See "Preparing your computer" on page 92.
2. Locate the thermal sensor. See "Major FRUs and CRUs" on page 34.
3. To remove the thermal sensor, do the following:
a. Disconnect the thermal-sensor cable from the thermal-sensor connector on the system board. See
"Parts on the system board" on page 37.
b. Pivot the drive bay assembly inward until it snaps into position. See "Completing the parts
replacement" on page 154.
c. Pivot the retaining clip
inward to release it and then disengage the plastic holder from the chassis.
Figure 82. Pivoting the retaining clip and disengaging the plastic holder
d. Press the release tab and pivot the drive bay assembly outward to open it. See "Preparing your
computer" on page 92.
136
P330 Hardware Maintenance Manual
1
that secures the plastic holder of the thermal sensor. Then, push the clip