• "Computer cover" on page 55
• "Optical drive" on page 56
• "Front bezel" on page 58
• "Drive bay assembly" on page 59
2. Disconnect the illuminated red dot cable from the system board.
Removal steps
Thermal sensor
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove these parts in order:
• "Computer cover" on page 55
• "Optical drive" on page 56
• "Front bezel" on page 58
• "Drive bay assembly" on page 59
2. Disconnect the thermal sensor cable from the system board.
Removal steps
.
Chapter 6
Hardware removal and installation
75