Setting The Host Responses - Fujitsu ETERNUS4000' ETERNUS8000 Server Connection Manual

Chapter 2 ETERNUS Disk Storage System Connection Settings
> 2.1 Common Settings
General Settings
Affinity Mode
Host Response
Reset Scope
Reserve Cancel at Chip Reset
Header Digest
Data Digest
2.1.2

Setting the Host Responses

The ETERNUS Disk storage system host responses must be set to match the way in which the
server will process the ETERNUS Disk storage system request responses.
These are different for each OS and this must be done before connecting the ETERNUS Disk
storage system to the server.
Retain the default values for all parameters not described below.
2.1.2.1 Solaris OS
For Solaris OS, perform the settings detailed in
Table 2.2
Solaris 10 OS
Table 2.3
Solaris 10 OS
2.1.2.2 HP-UX
For HP-UX, perform the settings detailed in
Table 2.4
HP-UX
Table 2.5
HP-UX
P3AM-4172-02ENZ0 Server Connection Guide (iSCSI) ETERNUS Disk Storage System Settings
Parameter
Reservation Conflict Response for Test Unit Ready setting for Solaris OS
OS
Conflict Response
Sense Data Conversion Pattern setting for Solaris OS
OS
Host Specific Mode setting for HP-UX
OS
Vendor Unique Sense Code setting for HP-UX
OS [Vendor Unique Sense Code] setting
12
Solaris OS, HP-UX, Windows®, Linux, VMware ESX
OFF (Default value): When not using Affinity Mode
ON: When using Affinity Mode
Not available ( When "Affinity Mode" is set to "ON")
I_T_L (Default value)
OFF (Default value)
OFF (Default value)
OFF (Default value)
Table 2.2 and Table
Setting
Sense Data Conversion Pattern setting
Linux Recommended (When not using GRMPD)
Table 2.4 and Table 2.5.
[Host Specific Mode] setting
HP-UX Mode (SCC)
No Report (Default)
2.3.
Copyright 2010 FUJITSU LIMITED