Transporting Lithium Batteries; Maintenance; Clearing Blockages - AEG ALM58LI402U Original Instructions Manual

TRANSPORTING LITHIUM BATTERIES

mal
Transport the battery in accordance with local and national provisions
40°,
and regulations.
ngle
Follow all special requirements on packaging and labelling when
n.
transporting batteries by a third party. Ensure that no batteries can
come in contact with other batteries or conductive materials while
in transport by protecting exposed connectors with insulating, non-
ible conductive caps or tape. Do not transport batteries that are cracked
wing
or leaking. Check with the forwarding company for further advice.
ecial

MAINTENANCE

WARNING! Use only original manufacturer's replacement parts,
dles accessories and attachments. Failure to do so can cause injury, can
contribute to poor performance, and may void your warranty.
WARNING! Servicing requires extreme care and knowledge and
ear should be performed only by a qualified service technician. Have
the product serviced by an authorised service centre only. When
servicing, use only original replacement parts.
Turn off the product, and remove the safety key and the battery pack.
Make sure that all moving parts have come to a complete stop before
any cleaning or maintenance task.
You may make adjustments and repairs described in this manual.
may
For other repairs, have the product serviced by an authorised service
oms
centre only.
ally
e to
Frequently check the grass catcher for wear or deterioration.
ght
After each use, clean the product with a soft, dry cloth. Any part that
are
is damaged should be properly repaired or replaced by an authorised
the
service centre.
Check all nuts, bolts, and screws at frequent intervals for proper
the
tightness to ensure that the product is in safe working condition.
It is
Be careful during adjustment of the product to prevent entrapment
g to
of the fingers between moving blades and fixed parts of the product.
When servicing the blades, be aware that even though the power
ood
source is turned off, the blades can still be moved.
The blade on the product is sharp. Use extreme caution and wear
day.
heavy-duty gloves when fitting, replacing, cleaning, or checking bolt
tely
security.
Replace damaged blades and bolts in sets to preserve balance.
ged

CLEARING BLOCKAGES

you
■ Turn off the product, and remove the safety key and the battery
pack. Make sure that all moving parts have come to a complete
stop.
ack.
■ Always wear heavy-duty gloves when checking or clearing a
low
blockage.
■ The blades are sharp, and the blockage itself could be a sharp
t in
object.
ren.
■ Remove the grass catcher, check for and carefully clear
den
obstructions.
■ Check and carefully clear the grass discharge chute from
the
blockages.
s or
■ Turn the product on its side, then check its underside and the area
around the blade. Carefully remove any blockages. Remember
the
that the blade may move during cleaning.
The
it is
SYMBOLS
Read and understand all instructions before
operating the product. Follow all warnings and
safety instructions.
Wear ear protection.
Wear eye protection.
Do not operate the product on inclines greater than
15°. Mow across the face of slopes, never up and
down.
Do not expose the product to rain or damp
conditions.
Beware of thrown or flying objects. Keep all
bystanders, especially children and pets, at least
15m away from the operating area.
Beware of sharp blades. Blades continue to rotate
after the motor is switched off . Remove the safety
key before maintenance.
To turn on product:
1. Press the start button.
2. Press and hold the on/off trigger.
Always remove the battery pack from the product
before cleaning, doing maintenance, or leaving the
product unattended.
Guaranteed sound power level
Class II tool, double insulation.
Regulatory Compliance Mark (RCM). Product meets
applicable regulatory requirements.
Waste electrical products should not be disposed
of with household waste. Recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
37
37